XNX Universal Transmitter - Merkantile

More documents

Recommendations

Info

XNX Universal Transmitteroutside the acceptable limits for the application follow the proceduresfor zeroing and calibrating the detector (see Section 3.2.1).3. If reading is still inaccurate replace the sensor (see Section 4.1).Once the Bump Test is completed successfully, the XNX will exit thecalibration procedure. Before returning to the Gas Calibration menuhowever, the user will be prompted to Exit and turn alarm and faultinhibit off, Exit and leave the XNX in inhibit mode, or do not exit.CautionExiting before the gas level has fallen below the level of Alarm 1 willcause the XNX to go into alarm.Figure 3-14. Calibrate mA Output Screens3.5 Align Excel (Searchline Excel)Figure 3-15. Align Excel MenuFor more detailed information on Aligning the Searchline Excel, seethe Searchline Excel Technical Manual (p/n: H-MAN0530-V1).3.4 Calibrate mA OutputUse Calibrate mA Output to adjust the milliamp output to provide thecorrect output levels at peripheral device(s) connected to the XNX.Figure 3-13. Calibrate mA Output MenuTo adjust the 4mA output, use the switches to increase ordecrease the output, then use to accept the new value and moveto the 20mA setting or to discard the selection and return to theprevious menu.Signal StrengthReference Value1.00 Signal Strength TargetFigure 3-16. Align Excel ScreenAlignment BargraphAlign the Searchline Excel unit using the information found in the TechnicalManual. As the alignment is performed, the XNX display will indicate thesignal strength in the form of a bar graph. Align the Excel until the signalstrength bar graph reaches or exceeds 1.00 as shown on the display.Section 3 - Calibration 3-83.5 Align Excel (Searchline Excel)
XNX Universal Transmitter3.7 Soft Reset(Searchline Excel and Searchpoint Optima Plus only)Figure 3-17. Soft Reset MenuFor XNX units connected to a Searchline Excel or Searchpoint OptimaPlus, the Soft Reset sends these infrared devices a signal to restartthe sensor.Figure 3-18. Soft Reset Sensor ScreenSection 3 - Calibration 3-93.7 Soft Reset
Page 4 and 5:
XNX Universal TransmitterTOCSafetyI
Page 6 and 7:
XNX Universal Transmitter5.4 Fault
Page 8 and 9:
XNX Universal Transmitter1.1 Produc
Page 14 and 15:
XNX Universal TransmitterThe Genera
Page 16 and 17:
XNX Universal Transmitter1.4.4 Disp
Page 18 and 19:
XNX Universal Transmitter2 Installa
Page 20 and 21:
XNX Universal Transmitter2.1 Mounti
Page 22 and 23:
XNX Universal Transmitter2.2 Wiring
Page 24 and 25:
XNX Universal TransmitterDisadvanta
Page 26 and 27: XNX Universal TransmitterXNX mV or
Page 28 and 29: XNX Universal TransmitterController
Page 30 and 31: XNX Universal TransmitterXNX Electr
Page 32 and 33: XNX Universal Transmitter10. Plug t
Page 34 and 35: XNX Universal TransmittermV Remote
Page 36 and 37: XNX Universal TransmitterXNXXNX S3
Page 38 and 39: XNX Universal TransmitterAttaching
Page 40: XNX Universal Transmitter• Releas
Page 43 and 44: XNX Universal TransmitterTB4RemoteR
Page 45 and 46: XNX Universal TransmitterNote:Calib
Page 47: XNX Universal TransmitterEnglish It
Page 51 and 52: XNX Universal TransmitterWhen the s
Page 53 and 54: XNX Universal TransmitterFigure 2-6
Page 55 and 56: XNX Universal TransmitterBlock Opti
Page 57 and 58: XNX Universal TransmitterUnit IDThe
Page 59 and 60: XNX Universal Transmitteroption, th
Page 61: XNX Universal Transmitter2.6 Verify
Page 65 and 66: XNX Universal Transmitter?Transmitt
Page 67 and 68: XNX Universal TransmitterFieldbus S
Page 69 and 70: XNX Universal Transmitter3 Calibrat
Page 71 and 72: XNX Universal TransmitterZero Calib
Page 73: XNX Universal Transmitter3.2.3 Zero
Page 78 and 79: XNX Universal Transmitter4 Maintena
Page 80 and 81: XNX Universal Transmitter4.2 XNX EC
Page 82 and 83: XNX Universal Transmitter5 Warnings
Page 84 and 85: XNX Universal Transmitter5.3 Warnin
Page 86 and 87: XNX Universal TransmitterWarningNum
Page 88 and 89: XNX Universal TransmitterFaultNumbe
Page 94 and 95: XNX Universal Transmitter5.5 Inform
Page 96 and 97: XNX Universal Transmitter6 Specific
Page 98 and 99: XNX Universal Transmitter6.1.1 XNX
Page 100 and 101: XNX Universal TransmitterGas type P
Page 106 and 107: XNX Universal Transmitter6.2 XNX Ce
Page 108 and 109: XNX Universal TransmitterXNX Part N
Page 110 and 111: XNX Universal TransmitterATEX Certi
Page 112 and 113: XNX Universal TransmitterXNXIDTarge
Page 114 and 115: XNX Universal TransmitterAccessory/
Page 116 and 117: XNX Universal TransmitterAccessory/
Page 118 and 119: XNX Universal Transmitter7.1 XNX Co
Page 120 and 121: XNX Universal TransmitterSection 7
Page 122 and 123: XNX Universal TransmitterA HART ®
Page 124 and 125: XNX Universal TransmitterDuring man
Page 126 and 127:
XNX Universal TransmitterHARTHandhe
Page 128 and 129:
XNX Universal TransmitterA.1.2 DevC
Page 130 and 131:
XNX Universal TransmitterCalibratio
Page 132 and 133:
XNX Universal TransmitterA.1.3 Hand
Page 134 and 135:
XNX Universal TransmitterMain MenuO
Page 136 and 137:
XNX Universal TransmitterMain MenuO
Page 138 and 139:
XNX Universal TransmitterB Modbus
Page 140 and 141:
XNX Universal TransmitterB.2 Modbus
Page 142 and 143:
XNX Universal TransmitterModbus Hol
Page 144 and 145:
XNX Universal TransmitterC Warranty
Page 146:
Find out morewww.honeywellanalytics
show all

XNX Universal Transmitter - Merkantile

Create successful ePaper yourself

Delete template?

Save as template?