GPS-NAVIGATOR GP-32 & GP-37

More documents

Recommendations

Info

1. OPERATIONAL OVERVIEW1.2 Turning On and Off PowerTurning on the powerPress the [DIM/PWR] key. The unit beepsand then starts up with the last-used displaymode.Turning off the powerPress and hold down the [DIM/PWR] key untilthe screen goes blank (about three seconds).The time remaining until the power is turnedoff is counted down on the display.Note: The example screens shown in thismanual may not match the screens you seeon your display. The screen you see dependson your system configuration and equipmentsettings.1.3 Adjusting Brilliance andContrast1. Press the [DIM/PWR] key momentarily.The display shown below appears.Your equipment takes about 90 seconds tofind its position when turned on for the veryfirst time. Thereafter it typically takes about12 seconds.The equipment shows receiver statusindication at the top left-hand corner in mostdisplay modes. The table below shows theseindications and their meanings.Indication2D3DD2DD3DReceiver status indicationsMeaning2D GPS position fix3D GPS position fix2D DGPS position fix3D DGPS position fixW2D 2D WAAS position fixW3D 3D WAAS position fixDOP* 2D: HDOP larger than 43D: PDOP larger than 6SIM Simulation modeBrilliance and contrast adjustment window2. To adjust the brilliance, press ? or ? .Current setting is shown to the right of ? .Maximum setting is 8.3. To adjust the contrast, press ? or ? .Current setting is shown to the right of ? .Maximum setting is 63.4. Press the [ENT] key to finish.Note: If the last-used contrast setting is 36 orhigher, the equipment starts up with thatsetting. If the setting is 35 or lower, theequipment starts up with setting 36.* = DOP (Dilution of Precision) is the index ofposition accuracy and is the distributionpattern of satellites used in position fixing.Generally, the smaller the figure the better theposition accuracy.2
1. OPERATIONAL OVERVIEW1.4 Display ModesYour unit has five display modes: Plotter Display, Highway Display, Steering Display, Nav DataDisplay and User Display (digital data and speedometer). Press the [DISP] key to choose adisplay mode. Each time the key is pressed, the display mode changes in the sequence shownbelow.Display modes (default user displays)Note 1: The unit measures distances up to 9999 nm. Any distance greater than 9999 nm isshown as “*999”.Note 2: Position data can be shown in latitude and longitude or TDs (Loran C or Decca).3
Page 3 and 4: iii
Page 5 and 6: 9. INSTALLATION....................
Page 8 and 9: SYSTEM CONFIGURATIONNote: This equi
Page 10 and 11: EQUIPMENT LISTSStandard supplyName
Page 14 and 15: 1. OPERATIONAL OVERVIEWPlotter disp
Page 16 and 17: 1. OPERATIONAL OVERVIEWUser display
Page 18 and 19: 1. OPERATIONAL OVERVIEW5. Press ? t
Page 20 and 21: 2. PLOTTER DISPLAY OVERVIEWCursor t
Page 22 and 23: 2. PLOTTER DISPLAY OVERVIEW(This pa
Page 24 and 25: 3. WAYPOINTS (MARKS)d) Press the [E
Page 26 and 27: 3. WAYPOINTS (MARKS)3.3 Displaying
Page 28 and 29: 3. WAYPOINTS (MARKS)3.6 Speed for C
Page 30 and 31: 4. ROUTES4. If necessary, change wa
Page 32 and 33: 4. ROUTESCreating a track-based rou
Page 34 and 35: 4. ROUTESPermanently deleting a way
Page 36 and 37: 4. ROUTES(This page intentionally l
Page 38 and 39: 5. DESTINATION5.3 Setting Route asD
Page 40 and 41: 6. ALARMS4. Choose ARV/ANC and then
Page 42 and 43: 6. ALARMS6.6 Trip AlarmThis alarm a
Page 44 and 45: 7. OTHER FUNCTIONS9. Press the [ENT
Page 46 and 47: 7. OTHER FUNCTIONSd) Use the cursor
Page 48 and 49: 7. OTHER FUNCTIONS7.5 Magnetic Vari
Page 50 and 51: 7. OTHER FUNCTIONS7.10 GPS SetupThe
Page 52 and 53: 7. OTHER FUNCTIONS8. Use the cursor
Page 54 and 55: 7. OTHER FUNCTIONSSAVING START? pro
Page 56 and 57: 7. OTHER FUNCTIONS1st byte: Skip co
Page 58 and 59: 8. MAINTENANCE & TROUBLESHOOTING8.3
Page 60 and 61: 8. MAINTENANCE & TROUBLESHOOTING6.
Page 62 and 63:
8. MAINTENANCE & TROUBLESHOOTING(Th
Page 64 and 65:
9. INSTALLATIONFlush mount S kitFlu
Page 66 and 67:
9. INSTALLATION9.4 Initial Settings
Page 68 and 69:
9. INSTALLATION(This page intention
Page 70 and 71:
APPENDIXAP-2
Page 72 and 73:
APPENDIXLoran C ChainsAP-4
Page 74 and 75:
APPENDIX(This page intentionally le
Page 76:
INDEXPPlotter display..............
show all

GPS-NAVIGATOR GP-32 & GP-37

Create successful ePaper yourself

Delete template?

Save as template?