GPS-NAVIGATOR GP-32 & GP-37

1. OPERATIONAL OVERVIEW5. Press ? to display “-“.6. Press ? to send the cursor to the nextdigit.7. Press ? or ? to display “0.”8. Press ? to send the cursor to the nextdigit.9. Press ? or ? to display “6.”10. Press ? to send the cursor to the nextdigit.11. Press ? or ? to display “3.”12. Press ? to send the cursor to the lastdigit.13. Press ? or ? to display “0.”14. Press the [ENT] key.15. Press the [MENU] key twice to finish.1.6 Simulation DisplayThe simulation display provides simulatedoperation of this unit. You may set the speedmanually and course manually orautomatically. All controls are operative - youmay enter marks, set destination, etc.1. Press the [MENU] key once or twice todisplay the menu.2. Choose SYS SETUP and then press the[ENT] key.3. Choose “SIMULATOR?” and then pressthe [ENT] key. (Note that position showndepends on language selected on theSYS SETUP menu. After changing thelanguage, the memory is cleared.)SIMULATOR menu4. The cursor is selecting MODE. Press the[ENT] key. A window shows the choicesON and OFF.5. Choose ON and then press the [ENT] key.6. Press the [ENT] key, use the cursor padto enter speed to use for the simulation,and then press the [ENT] key.7. Press the [ENT] key.8. Choose course (AUTO or MAN) and thenpress the [ENT] key. For manual entry ofcourse, press the [ENT] key, enter coursewith the cursor pad, and then press the[ENT] key. The AUTO course tracks acircular course.Note: Course must be AUTO to setsimulation destination.9. Press the [ENT] key, enter latitude withthe cursor pad, and then press the [ENT]key.10. Press the [ENT] key, enter longitude, andthen press the [ENT] key.11. Press the [MENU] key twice.12. Choose the PLOTTER display with the[DISP] key. SIM appears at the upperleft-hand corner when the simulatordisplay is active.Simulator display, auto course selected13. To turn off the simulator display, chooseOFF at step 5 in this procedure, press the[ENT] key and then press the [MENU] keytwice to finish.Note: If the power is turned off while thesimulator display is in use, the indicationSIMULATION MODE appears at the top ofthe screen at the next power up, in addition tothe indication SIM. SIMULATION MODEdisappears when any key is pressed,however the simulation mode continues.8