6 modules - PI-VR GmbH

7 CAD CONVERTER CLI164· tessqual=3: gridMode=AF_GRID_TO_EDGES;triMode=AF_ALL_TRIANGLES; edgeQLevel=_Better; chk_gen_pcurves=1;narrow_reg_repair=1; -edgeSagTol=1.0;· tessqual=4: gridMode=AF_GRID_TO_EDGES;triMode=AF_ALL_TRIANGLES; edgeQLevel=_BEST; chk_gen_pcurves=1;narrow_reg_repair=1; -edgeSagTol=1.0;• -surtol : surface tolerance:stol > 0.0: max. tessellation error is stol model units;stol = 0.0: surface tolerance is ignored for tessellation;stol < 0.0: => stol = |stol|*1/500*diag(bounding box(model));default is stol=-1• -nortol : normal tolerance: max angle between two adjacent trianglesof a tessellated surface; default is ntol=30• -maxEL : specifies the maximum edge length of a facet (triangle); defaultis mel=0.0 (to ignore max. edge length);• -triMode : specifies where to triangulate the grid (further subdivisionof the grid cells):· AF_NO_TRIANGLES_QUAD_TREE: the mesh should contain no triangles;· AF_NO_TRIANGLES_FULL_GRID: the mesh should contain no trianglesand the grid should be extended to face edges;· AF_TRIANGLES_ON_FRINGE_ONLY: the mesh should have trianglesonly on its fringe;· AF_ALL_TRIANGLES: the mesh should consists of triangles only;default is tMode=AF_ALL_TRIANGLES• -chk_gen_pcurves: check and generate pcurves: performance cost, but improvesrobustness against overly loose pcurves; specifies whether the faceteris allowed to generate new bs2_curves for use in faceting if the pcurves arenot tight enough;