SERIES

Cables and Peripheral Devices
Cables for Direct Drive Servomotors
SGMCS-
Servomotor
Model
Name
Length
(L)
Order Number *1
Appearance
SGMCS-
Flange specification
*2 : 1 or 3
Encoder-end Cable
(for incremental or
absolute encoder)
0.3 m JZSP-CSP15-E
SERVOPACK
end
L
Encoder end
SGMCS-
Flange specification
*2 : 1, 3, or 4
Cables with Connectors
on Both Ends (for
incremental or absolute
encoder)
30 m JZSP-UCMP00-30-E
40 m JZSP-UCMP00-40-E
50 m JZSP-UCMP00-50-E
SERVOPACK
end
L
Encoder end
*1. Flexible Cables are not available.
*2. Refer to the following section for the flange specifications.
Flange Specifications (page 395)
Flange Specifications
SGM7D-
Flange Specification
Code (6th
Digit)
4
5
: Applicable models
Flange Specification
Non-load side
installation
(with cable on side)
Non-load side
installation
(with cable on bottom)
Servomotor Outer Diameter Code (3rd Digit)
F G H I J K L
− − −
* − −
* Only leads on the side are available for the SGM7D-01G and -05G.
SGMCV-
Flange Specification Code
Servomotor Outer Diameter Code (3rd Digit)
Flange Location
(6th Digit)
B
C
1 Non-load side
4
Non-load side
(with cable on side)
: Applicable models
SGMCS-
Flange Specification
Servomotor Outer Diameter Code (3rd Digit)
Flange Location
Code (6th Digit)
B C D E M N
1
Non-load side − −
Load-side − − − −
3 Non-load side − − − −
4
Non-load side
(with cable on side)
− −
: Applicable models
Cables for Direct Drive Servomotors
395