SERIES

Cables and Peripheral Devices
Peripheral Devices
Batteries for Servomotors with Absolute Encoders
If you use an absolute encoder, you can use an Encoder Cable with a Battery Case connected
to it to supply power and retain the absolute position data.
You can also retain the absolute position data by supplying power from a battery on the host
controller.
Using Encoder Cables with Battery Cases
A Battery Case is attached to an Encoder Cable with a Battery Case. To replace the battery,
obtain a Lithium Battery (JZSP-BA01) and mount it in the Battery Case.
Important
1. You cannot attach the Battery Case to an Incremental Encoder Cable.
2. Install the Battery Case where the surrounding air temperature is between -5°C and 60°C.
Note: The cable and connector to connect the Encoder
Cable and Battery Case are not included.
Encoder Cable with Battery Case
SERVOPACK
Connector
Mount a Lithium Battery.
Battery Case (JUSP-BA01-E)
Lithium Battery (JZSP-BA01)
Selection Table
Name Order Number Remarks
Battery Case (case only) JUSP-BA01-E
The Encoder Cable and Battery are not included.
(This is a replacement part for a damaged Battery Case.)
Lithium Battery
JZSP-BA01
This is a special battery that is mounted into the Battery
Case.
Lithium Battery Dimensional Drawing
2
Red
1
Red
Connectors
Battery
ER3V (3.6 V, 1,000 mAh, from Toshiba Battery Co., Ltd.)
When Installing a Battery on the Host Controller
Use a battery that meets the specifications of the host controller.
Use the recommended Battery given in the following table or the equivalent.
444