2018 Adhesives and Sealants Equipment Guide

Adhesive & Sealants Equipment Guide
Web Content
Foam Systems | 2-15
FoamMelt ® Processors
200 Series
Description
FoamMelt FM200 processors melt thermoplastic
adhesives and sealants, mix them in solution with
precisely controlled quantities of an inert gas (CO 2
or
N 2
) via a two-stage gear pump, and deliver a foam hot
melt of uniform density.
Processors include adjustable foam density control,
individual temperature control of heat zones,
temperature control accuracy to within ± 0.5 °C (1 °F)
of setpoint, overtemperature protection, and electrical
quick disconnects for hoses, applicators and solenoids.
The FoamMelt processor line includes a wide selection
of models with varying capacities, reservoir types,
melt rates and controls to meet specific adhesive and
application requirements.
• Provide individual temperature adjustments for tank and/or
grid and reservoir.
FoamMelt 200 Processor
• Include 3 horsepower, variable-speed AC electric drive.
• Include a density controller assembly for handling hot melt
viscosity ranges of 1,000 to 40,000 cps, including general
purpose hot melts with relatively long pot lives and pressuresensitives.
• Electronics meet IEC norms for static discharge and couplednoise
immunity.
Front Mounted Hydraulic System Controls
The FM 200 unit incorporates the advanced Vista control system, which improves productivity by automating
many operator functions. Vista controls offer the following features:
• Superior noise immunity through advanced components and
design techniques.
• Fully-compatible with existing Nordson RTD applicators and
hoses.
• Control design permits customization of most system settings
with password protection to minimize unauthorized access.
Easy-to-operate control membrane with bright LED displays
of actual and setpoint temperatures provide quick verification
of all heat zones.
• Standard 7-day clock with manual override allows automatic
start-up and shutdown for each day of the week. Reducedtemperature
standby mode minimizes adhesive degradation
and lowers unit energy consumption during idle periods.
• Programmable temperature alarm bands for each zone
monitors and identifies potential problems before operation
is effected. Other programmable features include overtemperature
setpoint, sequential or simultaneous start-up,
display of heater proportioning, and Celsius or Fahrenheit
display.
• Output contacts for System-Ready, Fault and Warning
functions allow automated remote monitoring of system
status.
• Advanced diagnostics quickly locate a fault condition to help
facilitate servicing.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com