2018 Adhesives and Sealants Equipment Guide

Adhesive & Sealants Equipment Guide
Automatic Applicators | 7-39
Box
7
Box
8
50-mesh, straight
50-mesh, 45° angle
50-mesh, 90° angle
100-mesh, straight
100-mesh, 45° angle
100-mesh, 90° angle
200-mesh, straight
200-mesh, 45° angle
200-mesh, 90° angle
Saturn Inline Filters
Description
Code
E0
E4
E9
F0
F4
F9
G0
G4
G9
On slim single-module applicators, the hose
connector is located just above the integrated
filter. On single- or multimodule configurable
applicators, the filter is inline with the hose
connector.
Additional Hose Ports
(all applicators have three hose ports)
Description
One hose port on each end and one centered
on back.
Code
3
Box
9
Box
10
Box
11
SD (small)
Line speeds
Solenoid Valve Type
Description
90 m/min (295 ft/min)
SG (Saturn) All line speeds
SD solenoid valves may not be used in
common air applicator configurations.
If the production line speed is 90 m/
min (295 ft/min) or less, either SD or
SG solenoid valves may be used. If the
production line speed is greater than 90
m/min (295 ft/min), only SG solenoid
valves may be used.
Voltage
Description
Code
SD
SG
Code
230 VAC A
200 VAC B
Programmed Air Groups
Description
Code
One hose port on each end and three on
back (one in the center and one at each end)
5
Programmed air (two module groups only)
200 VAC B
PA
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com