2018 Adhesives and Sealants Equipment Guide

Adhesive & Sealants Equipment Guide
Web Content
Automatic Applicators | 7-17
Select Series Applicators
Description
Select Series Applicators provide Nordson quality applicators to fit melters from ITW/Dynatec Hot Melt
Technologies (HMT®) or Robatech. The Select Series applicators are equipped with the appropriate cordsets and
proper electrical/hudraulic connectors for easy installation onto other manufacturers’ melters.
Select Series automatic applicators are available in air-open-spring-close or air-open-air-close versions as offered in
the Best Choice Series. These applicators deliver many benefits, including:
• Industry-leading service life that enhances productivity.
• Choice of Air-open/Spring-close or Air-open/Air-close versions.
• Consistent life module to module maximizes uptime through predictable behavior.
• Superior cutoff. Even with difficult materials, delivers accurate bead placement and attractive packages.
• Excellent module-to-module synchronization on closing.
Use the Best Choice Configurator to select your new/replacement applicator.
Best Choice Applicator Configuration Code
The Best Choice configurator will help you select the applicator best suited to your application. Contact your
Nordson representative to obtain the configurator program. Below is a typical configuration code listing and a
table that interprets the code. When a configured applicator is ordered, Nordson assigns a unique identifier code
to the assembly, and that number is stamped onto the applicator identifier plate. The identifier code can then be
used to order new configured applicators, forgoing the configuration process.
Applicator
Model
Module
Type
Number of
Modules
Voltage Air Type Module
Spacing
Cordset
Cordset
Position
Solenoid
Saturn Inline
Filters
Number of
Hydraulic
Ports
SURS STD 04 A CA 022 T LB 3A0A E9 3
1 2 3 4 5 6 7 8 9 10 11
Box
1
Applicator Model
Box
2
Module Type
Description
Code
Description
Code
ClassicBlue Reduced Cavity
CBRC
Standard
STD
ClassicBlue Zero Cavity
CBZC
Right Angle (Classic Blue Only)
RA
ClassicBlue Zero Cavity Extended
CBZE
Zero Cavity
ZC
ClassicBlue Right Angle
CBRA
Reduced Cavity
RC
SureBead S (air-open-spring-close) (AO/SC)
SURS
Zero Cavity Extended
ZE
SureBead A (air-open-air-close) (AO/AC)
SURA
SolidBlue S (AO/SC)
SLBS
SolidBlue A (AO/AC)
SLBA
NOTE: Solid Blue S replaces Classic Blue Standard.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com