2018 Adhesives and Sealants Equipment Guide

Adhesive & Sealants Equipment Guide
Web Content
Automatic Applicators | 7-59
Series EM-100 Electric Applicators
Description
Nordson EM-100 electric applicators provide the
versatility of attaching one to eight valve modules to
a single heated manifold that is supplied by a single
hose. The EM-100 applicator extrudes beads or dots
of adhesive or other thermoplastic material for a wide
range of packaging and product assembly applications.
The inlet to the applicator manifold uses Nordson’s
standard O-ring port, and is compatible with the
Nordson Saturn® inline filters.
EM-100 applicators allow users to specify the
number and spacing of modules needed for a specific
application. The spacing from nozzle tip to nozzle tip
can be as close as 44.45 mm (1.75 in.) and up to a total
manifold width of 609.6 mm (24 in.).
EM-100 applicators accept AC or DC signals to
energize the electric coil on standard or high-speed valve
modules. The path for driver signal to the EM-100
applicator coil is provided by an external signal cable
assembly (purchased separately). Two screws attach the
valve modules to the manifold for quick removal or
replacement. EM-100 applicators eliminate the need
for compressed air or a complex valving mechanism.
The valving assembly consists of a single moving part,
two static O-rings and a solenoid mounted on the valve
block.
All ports are electrically active. Individual valve modules
and blanking kits arrange on the manifold to yield
specific adhesive pattern spacing. A choice of left, right,
or top feed port to the manifold is available and must
be specified for each manifold. The product uses the
same nozzles as the Slautterback E-100, E-100XT,
M-100 and the Nordson H-20 applicators.
Features
EM-100 Electric Applicator
• Operates at up to 6000 cycles per minute to meet the most
demanding applications.
• Arrangement of up to eight individual valve modules on the
manifold yields specific adhesive pattern spacing.
• All electric design ensures performance and reliability.
• Versatile design and wide nozzle spacing allows for use in a
wide range of packaging and product assembly applications.
• Resistance temperature detector (RTD) sensors offer precise
temperature control to within ±1 °C (1 °F) for exceptional
pattern consistency.
• Compatible with Nordson Saturn in-line filters.
NOTE: The EM-100 Series electric applicators can be driven by
various devices. Refer to the Applicator Driver Selection
Chart and the Applicator Driver Comparison Chart in the
Controls section for more information.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com