2018 Adhesives and Sealants Equipment Guide

Adhesive & Sealants Equipment Guide
Controls | 13-41
Web Content
LogiComm ® OEM Applicator Driver Board
Description
The LogiComm OEM applicator driver board is a highperformance,
four-trigger, four-output channel electric
applicator driver that easily installs in an OEM control
cabinet to interface with a PLC. The driver comes
programmed with settings for the e.dot® series electric
applicator but can be reprogrammed via a computer to
drive many other hot melt or liquid adhesive electric
applicators.
LogiComm OEM applicator drivers support
communication to the PLC via the digital I/O. The
customer can reset the driver to a fault condition or
enable the driver. Additionally, a driver contact is
opened upon a fault such as an open or short coil or a
thermal fault.
LogiComm OEM Applicator Driver Board
Features
• Program driver settings via computer
• Four trigger inputs and four output channels
• Small driver size, DIN rail mounting and two-piece plug type
connectors facilitate installation in an OEM control cabinet
• Each output can be:
––
programmed to drive different applicator types
––
tested independently via a purge button or a signal from a PLC
• Two trigger modes are available: normal/bead and dot
• Four status LEDs for trigger, output, dot mode and fault
(short and open coil detection)
• Fully programmable to support current and future Nordson
applicators
• Fully serviceable
• USB connection:
––
allows field software upgrades
––
allows uploading of new settings through software
––
allows ability to back up settings
• Digital I/O:
––
enable/disable driver or reset the driver from a fault condition
––
fault contact opened if an open/short coil is detected or a thermal
fault
• Modbus TCP communications
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com