2018 Adhesives and Sealants Equipment Guide

13-36 | Controls
Applicator Driver Selection Chart
LogiComm OEM
Applicator Driver Board
LogiComm
Applicator Driver
e driver
Features:
Applicators
e.dot+, e.dot, E-400, All hot melt and liquid e.dot
LA 820, WM 801 adhesive electric applicators
Outputs 4 4 or 8 1
Coils Per Channel 1–2 in series Varies per applicator 1–3 in series
Input Triggers 4 4 1
Normal Mode Yes Yes Yes
Dot Mode Yes Yes Yes
Dot Time 0.05–4.95 ms 0.05–12.70 ms 0.05–4.95 ms
Purge Yes Yes Yes
Flush Yes Yes Yes
Hammering Yes Yes Yes
Programming:
Spike Amplitude
Software LCD / Keypad Software
Spike Duration Software LCD / Keypad Software
Hold Duration Software LCD / Keypad Software
# Coils Wire in series LCD / Keypad Wire in series
User Interface:
Interface
Diagonistic LEDs — power Backlit LCD graphic with LEDs: power, trigger, output, 3
(230V and 24V), enable, fault keypad and on/off switch. 4 thermal LEDs (fault warning or
(short/open circuit) LEDs for triggers, 4 to 8 LEDs OK), open, short, dot, for each
Diagnostic LEDs per channel— for outputs, LED for power, LED channel; purge button (press in);
trigger, output, fault, dot mode/ for fault, and LED for alarm. two knobs for adjusting dot time.
purge
Purge button and buttons to
scroll through LCD
Connections Terminal Block Terminal block or Connector Terminal Block
Other:
Special Features
Modbus TCP communication
Ready output — potential free
contact rated at 0.25 A @
24 VDC, closes on unit ready
Presets for all legacy
applicators, current mode and
HD mode
Port for software to set applicator
settings
Software Upgrades Software utility USB 2.0 and 1.1 via NCM None
Major Replacement
Parts
Full set of service kits Full set of service kits None
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com