2018 Adhesives and Sealants Equipment Guide

16-4 | Accessories
In-Line Filters
Heated In-line Filters
Inserted between the hose and applicator, the heated in-line filter provides final adhesive filtering immediately
before applicator deposition. It helps balance temperature swings in extreme environments and removes char
or contaminants that can cause nozzle clogging. The filter consists of a large surface-area filter screen assembly
contained in a heated aluminum body.
• Use with high-viscosity hot melts over 10,000 centipoise.
• Cartridge heater and button thermostat provide independent
heat and temperature control. Nordson does not recommend
combining the thermostatically-controlled filter with RTDstyle
hoses and applicators.
• Choice of thermostat settings ranges from 50° to 230°
• °C (120 to 450 °F) to maintain operating temperature
consistency throughout the system. Specify required
thermostat when ordering; otherwise, a 175 °C (350 °F)
thermostat is standard.
• Selection of filter screen mesh sizes matches application
requirements to maximize filtration. Each filter includes
a 0.15 mm (0.006 in.) screen. Order different mesh sizes
separately.
• Filter screen is readily accessible for removal and cleaning.
Drain valve flushes loose contamination out of the body
during filter-screen removal.
• Filter is wired in parallel with the applicator and includes two
armored cordsets; one attaches the filter to the hose, while the
other replaces the standard applicator cordset and attaches the
applicator to the filter.
• When used with H-200 applicators and Series 2000
applicators, discard the upper filter cordset (P/N 242077)
and replace with the applicator cordset to connect the filter
to the hose. The lower filter cordset connects the filter to the
applicator.
Specifications
Electrical service
Parameter
Specification
240 VAC 50/60 Hz
120 VAC, 50/60 Hz (includes 145 W heater)
Parts and Accessories
Part Number Description Comment
309100 Filter, 240 VAC
803124 Filter, 120 VAC Includes heater, 145 W, 120 VAC, P/N 803123.
803231 Filter, Drum Melters, 240 VAC
Attaches to 5/16 in. hose fitting at manifold and uses 5/8
in. hose fitting on the output side.
249954 Filter Screen, 0.05 mm (0.002 in.)
161133 Filter Screen, 0.10 mm (0.004 in.)
161130 Filter Screen, 0.15 mm (0.006 in.) Shipped with filter.
161134 Filter Screen, 0.23 mm (0.009 in.)
Dimensions
Dimension
mm (in.)
Height 141 (5.6)
Depth 64 (2.5)
Width 51 (2.0)
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com