VisCAM RP User Manual (PDF) - Kxcad.net

VisCAM Help 4.0
The stack position is set to the last (topmost) layer of the model.
Loop mode
If this option is enabled, the stack animation runs endlessly through all layers. Otherwise the
animation is stopped at the last layer.
Delay time
You can define a delay in milliseconds that is used by the slice animation. Every layer is at least
displayed for this amount of time before the next layer is displayed.
Single slice
Only one layer is displayed at once. Otherwise all slices from the bottom most up to the actual
layer are displayed.
Add slice below
In addition to the actual slice, the slice below is displayed.
Slice details
Using the button Slice details you can expand the dialog, so that detailed information about the
currently displayed slices is shown.
Slices
The number of displayed slices, the displayed information refers to.
Thickness
The thickness (per slice) in mm.
Hatches
Sum of the hatches of the displayed slices.
Support edges
Sum of the support edges of the displayed slices.
Volume
Volume of the displayed slices in ccm.
Contour area
Area of the displayed slices in qcm.
254