VisCAM RP User Manual (PDF) - Kxcad.net

VisCAM Help 4.0
Write PLY binary format: If this options is selected PLY files are saved in binary format (default
setting). If unselected PLY files are written in ASCII format.
Write FS with format version 3.0: If this options is selected F&S files are written in version 3.0
(default setting). If unselected F&S files are written using version 2.1.
HINT: The use of binary formats reduces the amount of memory needed for saving a model. On
the other side ASCII formats can be manually edited using a standard text editor.
Set default file unit values
See help page for the dialog Set default file unit values.
Registered file formats:
Here you can select the file types that VisCAM RP uses to register itself within the Windows
operating system. These file types can be opened using a double click within the Windows File
Explorer.
For every file format the link to VisCAM can be switched on or off. The registration within the
Windows system is done when closing the dialog by pressing the OK button.
Using the button Register all formats all supported formats can be linked with VisCAM
immediately und registered within the Windows system.
Reference: Open, Save as, Set default file unit values
342