1 - page screenshot of chlodzenie.pl

Insulation work 5CSL0-06B
2.4 Insulation work
2.4.1 Insulation
1) Operational steps
1 EPDM length should be more
longer than pipe length.
Do not extend EPDM by force.
2) Bending vertical side of insulation
1 Use the original uncut insulation
material.
2 Put the pipe in EPDM insulation 3 Bond on both side of cut surfaces 4 Dry it until it becomes thick, sticky
carefully so that the pipe will not of move sure to use the correct type and does not get detached.
get damaged with EPDM.
of bond for EPDM cut surface
attaching.
2 Only in specialcase is the vertical 3 Bond both sides of the surface of 4 Dry it until it becomes thick and
cutting of the insulation allowed. EPDM and press them together for
long lasting bonding.
sticky.
3) ' L'
Fitting connection part insulation
1 All of the fitting connecting parts 2 Make fitting cover to fit the EPDM 3 Bond the both cutting sides of
should be insulated.
insulation fitting cover should be fitting cover.
Bring face to face the each end of overlapped with insulation min 1
EPDM on fitting connection part. inch (2.5cm).
304 Guideline for each installation process