1 - page screenshot of chlodzenie.pl

Control system 5CSL0-06B
Installer Setting -How to enter installer setting mode
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user injury or property damage.
This must be set by an certificated installer, and any installation or change that is carried out by a non-certificated
person should be responsible for the results. In this case, free service cannot be provided.
1
❈ Some contents may not be displayed depending on the product function.
1
2
Press button for 4 secsonds to enter
the installer setting mode. (When you
enter the setting mode initially, Function
code is displayed on the bottom of the
LCD screen.)
Function Code Value
Repeat pressing button, the menu
will change with the corresponding
function code.
Test Run → Address Setting → E.S.P.
Value → Thermistor → Ceiling Height →
Static Pressure → Group Setting →
Override Setting → Dry Contact →
Release 3Min. Delay → Zone State →
Convert Temp. → Plasma → Electric
heater → Humidifier → Elevation Grill →
Ventilation Kit
38 General information