1 - page screenshot of chlodzenie.pl

Console (Floor stand)
3.5.2 Selection of the best location
Install the air conditioner in the location that satisfies the following
conditions.
1.There should not be any heat or steam near the unit.
2. Select a place where there are no obstacles around of the
unit.
3. Make sure that condensation drainage can be conveniently
routed away.
4. Do not install near a doorway.
5. Ensure that the interval between a wall and the left (or right)
of the unit is more than 300mm.
6. Use a metal detector to locate studs to prevent unnecessary
damage to the wall.
7. It is away from electronic ignition type fluorescent lamps as
they may shorten the remote controller range.
8. Please check at least 1m away from television or radio.(It
cause interference with the picture or sount)
NOTE
• Before choosing the installation site, please obtain user
approval
• If the unit is installed below a window,check the interference
of window curtain.(more than 300mm)
• Because of dust problem, If the bottm height "H" is less
than 100mm, Keep the bottom vane close not to make
dust from the bottom.
More than
300
250 or less
from the Floor
More than 300
More than
300
(Unit : mm)
3.5.3 Installation
1) Preparation / Removing front panel
5CSL0-06B
① Open the front grille by pulling forward
② Then pull out the link of grille from groove in front panel.
③ Then pull out 2 hinges of grille from grooves in front
panel.
④ Then remove 4 screws, dismount the front panel while
pulling it forward.
2) Preparation / For Moldings , Side Piping,
and Concealed Installation
① For Moldings
• Remove the slit portions on the Rear Panel.
Remove
348 Installation of indoor unit