1 - page screenshot of chlodzenie.pl

5CSL0-06B Ceiling concealed duct (High static)
- With drain pump
① Possible drain head is upto 700mm.
② Keep the drain pipe downward stope upto 1/50~1/100.
Prevent any upward flow or reverse flow in any part.
③ 10mm or thicker insulation should be provided for the
drain pipe.
Unit
Drain Pipe
Drain Pump
3) Checking the drain
1) Checking the drain
① Remove the air filter.
MAX 700mm
Elbow
Drain pump
1/50~1/100
Thermal insulattion
(Local supply)
Drain pipe
(Local supply)
2. Check the drain.
① Poor eough water on the drain pan.
② Ensure that water flows through the drain pipe from
indoor unit without any leakage.
3.4.6 Electric wiring work
1) General instructions
① All field supplied parts and materials, electric works must
conform to local codes.
Use copper wire only.
② Follow the "WIRING DIAGRAM” attached to the unit
body to wire the outdoor unit, indoor units and the remote
controller.
③ All wiring must be performed by an authorized electrician.
④ This system consists of multiple indoor units. Mark each
indoor unit as unit A, unit B..., and be sure the terminal
board wiring to the outdoor unit and indoor unit are properly
matched. If wiring and piping between the outdoor
unit and an indoor unit are mismatched, the system may
cause a malfunction.
⑤ A circuit breaker capable of shutting down the power
supply to the entire system must be installed.
Installation of indoor unit 345