WSCAD51 Getting Started - FTP Directory Listing

Getting Started
Close the Terminal browser with 'OK' and confirm 'Save modifications?' with yes. Now
all numbers are written to the terminals.
Input via Terminal Number
With this method, you can assign the terminal number separately for each individual
terminal. In the menu, select 'Modify – Terminal / Cable numbers' and from the '-
X1' terminal strip select the first terminal.
At the prompt (Input Pin Number) type in '1' and confirm with . The terminal is
now labeled and you are immediately prompted for the next terminal in the terminal
strip. Continue until you have reached the 'PE' connection of motor M1 (M2 as well).
Here enter 'PE' as the designation. (But you should increase your logical terminal
numbering by one for the next terminal number).
Confirm the existing inputs with (if you don't want to change it), when you
reach the final connection in the terminal strip of the current drawing sheet, the input
routine will be terminated.
Drawing macros
Inserting drawing macro
Now you will add an additional symbol to your drawing using a previously created device
that has been stored as a so-called 'Drawing Macro'. Drawing Macros contain
components, lines and text, etc. that have been created from existing sections of
42