WSCAD51 Getting Started - FTP Directory Listing

Design capture
Assign the coil to the virtual contactor with the function text '!Feed forward'. After
OK You will see the Component Parameters with the function text already entered.
It is still marked as invisible (with a prefixed '!'), click on function text and select from
following menu 'Modify' now you'll be able to delete the '!'. Now position the text below
the coil. Place the text in the same horizontal position as the function text 'Table up'
and 'Table down' for the valves. Place the virtual contactor 'Feed backward' at
200.0 / 82.5 mm, and place the function text below the coil. Now do the same for the
contactor 'Worm on' at 235.0 / 82.5 m m.
Contact
Now place a 'NC_power' from the 'Favourites' library for the blocking circuit of the
reversing starter and position it above the coil 'Feed backward' at 165.0 / 97.5
mm. Assign it to the coil '!Feed forward' and confirm with 'OK'. Place another
'NC_power' and position it above the coil 'Feed forward' at 165.0 / 97.5 mm. Assign
it to the coil 'Feed backward' and confirm with 'OK' again. Place two 'NO_power' at
37.5 / 180.0 mm and 37.5 / 162.5 mm and assign these to the motor circuit breakers
('Feed' and 'Worm').
53