WSCAD51 Getting Started - FTP Directory Listing
WSCAD51 Getting Started - FTP Directory Listing
WSCAD51 Getting Started - FTP Directory Listing
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Getting</strong> <strong>Started</strong><br />
Connecting coils and contacts<br />
On page two you are going to draw the complete low voltage (control) circuit. Go back<br />
to the main menu and switch to page 2 using either the key, or 'Page<br />
up/down' command on the 'File' menu. In the appearing window you can select the<br />
page directly. Note the preview beside the selection window.<br />
On the 'File' menu, select the command 'Insert drawing macro'. Select the preprepared<br />
drawing macro 'Val.0000' and position it on the coordinates 95.0 / 72.5 mm.<br />
Note<br />
Hint<br />
52<br />
Drawing Macros are pre-prepared parts of diagrams which you can<br />
insert into your diagram enabling you to quickly draw similar<br />
drawing arrangements again and again. They can be created using<br />
the command 'File/save drawing macro'.<br />
Note that the destination assignments of the terminal connections<br />
for –X4 have been partially reversed (internal/external swapped<br />
over)<br />
Coil<br />
Now select the coil 'Contactor_power' from the Favourites 'EXAMPLE' library and<br />
place it with the 'Spacebar' on the coordinates 165.0 / 82.5 mm.