WSCAD51 Getting Started - FTP Directory Listing
WSCAD51 Getting Started - FTP Directory Listing
WSCAD51 Getting Started - FTP Directory Listing
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Buttons for the<br />
destination<br />
wiring<br />
Rule<br />
Design capture<br />
The symbols have a common connection and 2 destinations:<br />
Target 1 and Target 2. The arrow always shows the common<br />
connection and must always be connected to a component. The<br />
black line is the first destination and the red line the second<br />
destination.<br />
For example, a wire has two connection points. One end of the wire<br />
is the common connection and the other end is the first<br />
destination.<br />
The common connection must only be connected to a symbol (also<br />
possible via an angle piece).<br />
Angle pieces are disregarded in practice.<br />
Shortcuts<br />
There are several ways of loading angle pieces. As well as the library, you can also use<br />
a symbol bar.<br />
However, the most effective way is to load destination-wiring symbols is by using<br />
Shortcuts instead of selecting the DW elements with the mouse. In this way, you can<br />
increase your work rate rapidly.<br />
WSCAD supports the following shortcuts for the DW ele ments:<br />
Shortcut DW-Elements<br />
- Left arrow T-Pieces left<br />
- Right arrow T-Pieces right<br />
- Up arrow T-Pieces up<br />
- Down arrow T-Pieces down<br />
- Left arrow Arrows<br />
- Right arrow "<br />
- Up arrow Corners<br />
- Down arrow "<br />
A small dialog appears when using shortcuts offering the<br />
corresponding DW elements.<br />
You can also navigate using the arrow keys. Make the<br />
selection with the key and exit with the <br />
key.<br />
69