WSCAD51 Getting Started - FTP Directory Listing

Getting Started
Replace the 'Function text' input line with '!MPCB Worm' (it means a worm drive) and
position it again below the circuit breaker.
Method 2: The contacts are placed first and the coil is assigned to
the contacts later (virtual contactor)
Now draw the main circuit for motors M1 and M2. For this you need three 3-pole main
contacts, which you will find via 'Schematic - Load symbol ...' under
'NO_3pol_power'. Position the first contact at 90.0 / 130.0 mm.
48