WSCAD51 Getting Started - FTP Directory Listing

Getting Started
Therefore you will only need to load a 'Dummy’ entry from the database, in order to set
the dimensions of the mounting plate. This part has a preceding '.' (full stop) to exclude
it from the material list.
Click on 'Supplements' in the open 'Control Cabinet Manager' and select the
database entry 'AE cabinet compact one door' (part number
'.AE1060600'). Position the mounting plate to the co-ordinates 750,0/575,0 mm. Exit with
'Abort + remove' and quit the 'Control Cabinet Manager'.
Drawing Cable trays, top hat rails and collection
bars
92
Now place the cable trays on the mounting plate. Select a cable tray via the
adjacent symbol.
The database selection opens again. Select 'Cable tray' with part number
'KL25/60'. Ignore the activated text input field by pressing .
Hint
If you already know the length of the cable channel you can enter
this into the input field.
• Set the 1. vertical tray on the co-ordinates 762,5/837,5 mm and the end point
at 762,5/300,0 mm. Close the opening symbol parameters.
• Start the 2. vertical tray at 1312,5/837,5 mm, with the end point at
1312,5/300,0 mm.
• Place the 1. horizontal tray on the co-ordinates: 787,5/837,5 mm to
1312,5/837,5 mm.
• The 2. from 787,5/687,5 mm to 1312,5/687,5 mm.
• The 3. from 787,5/512,5 mm to 1312,5/512,5 mm.
• And the last from 787,5/387,5 mm to 1312,5/387,5 mm.
The top hat rails are drawn in the same way as the cable channels.
Load a top hat rail and select the database entry 'Top hat rail perforated'.
Set the first co-ordinate at 787,5/762,5 mm and the end point at 1312,5/762,5 mm.
Then place three more top hat rails, from 787,5/600,0 mm to 1312,5/600,0 mm,
from 787,5/450,0 mm to 1312,5/450,0 mm and from 787,5/337,5 mm to
1312,5/337,5 mm.