519FLA REPAIR MANUAL

00006
00007
00008
00/08/01 5 HP 19 FL © ZF Getriebe GmbH Saarbrücken CD
Turn the housing through 90° with the
converter bell downwards.
Important:
For adjusting work, see Chapter 1.4.6
Place shim washer 35.040 on pinion shaft
35.010/130.
Install inner bearing race 35.020 on the
pinion shaft in the mandrel press, using
drift 5x46 002 217. Install the bearing
spacing washer and outer bearing race.
Install the other inner bearing race in the
mandrel press, using drift 5x46 002 217.
Important:
For adjusting work,
see Chapter 1.4.3.1 + 1.4.3.2
Screw locknut 35.030 with fixture 5x46
002 174 on to the pinion shaft and caulk
into position.
To do this, clamp retaining fixture 5x46
042 174 horizontally into the vice.
Place wrench 5x46 012 174 on the pinion
shaft locknut.
Also pass insertion tool 5x66 000 030
(wrench connected to torque wrench)
over the pinion shaft, then push the pinion
shaft into the splines of the retaining
fixture and tighten the locknut.
(Tightening torques: see Chapter 1.5)
3.1/5