519FLA REPAIR MANUAL

99007
99090
00/08/01 5 HP 19 FLA © ZF Getriebe GmbH Saarbrücken CD
5.3 Removing parts from transmission
housing
Detach spring from pinion shaft.
Remove bearing retaining ring by hand or
with a 2-arm puller.
Heat the bearing race with a hot air
blower and remove the outer bearing race
and shim washer. Make sure that the
shim washer and outer bearing race are
kept with the correct bearing.
Important:
Do not damage the sealing face.
Continue removal work as described in
the section for the 5HP19 FL.
Remove the outer bearing races from the
transmission housing with tool 5x46 022
002 combined with 5x46 021 008 or
5x46 021 007.
Important:
A plastic plate must always be placed
between the support bracket and the sealing
face, or else the sealing face will be
damaged beyond repair. Make sure that
the outer bearing races and shim washers
are kept with the correct bearings.
Do not accidentally interchange them
➮ noise problems ➮ transmission failure
5.3/1