519FLA REPAIR MANUAL

1.4.5.2 Pinion projection
Insert the complete pinion with the
closed side first into the front-axle
housing.
Turn the pinion several times.
Place the dial gauge from measuring bar
5p01 150 331 on measuring ring 5p01
020 356 and set to “0”.
Place the measuring ring on the frontaxle
housing, place measuring ring 5p01
040 356 on the pinion and measured as
far as the measuring ring with the
measuring bar ➮ M R
Calculation:
Pinion projection is obtained as follows:
M RA = K RV - K RR + M R - K D
Washer thickness is obtained as follows :
S M = (S MIN + S MAX ) / 2
S R = M TA - M RA - S M
1.4/28
CD
5 HP 19 FL © ZF Getriebe GmbH Saarbrücken
00034
00035
00036
00/08/01