519FLA REPAIR MANUAL

Insert cup spring 72.110, press the cup
spring down with assembly fixture 5x46
002 005 and secure with split retaining
ring 72.140.
Insert clutch disc set B.
To do this, insert corrugated spring
72.064 - if fitted -, then steel discs
72.070 and lined discs 72.080 alternately.
Add end disc 72.090 and secure with
snap ring 72.100.
Note:
If according to the parts list the disc set
does not include a corrugated disc,
adjustment is not necessary: otherwise:
Important:
Adjusting work: see Chapter 1.4.1.6
Install thrust bearing 71.200 on cylinder
A.
Installed position (see picture)
Align the lined discs for clutch B and
insert over cylinder A, turning them at
the same time.
3.6/8
CD
5 HP 19 FL © ZF Getriebe GmbH Saarbrücken
98348
98351
99206
00/08/01