519FLA REPAIR MANUAL
519FLA REPAIR MANUAL
519FLA REPAIR MANUAL
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1.4.6 Bearing adjustment, output<br />
gears<br />
1.4.6.0 Preparation for bearing adjustment,<br />
shim washers<br />
Place front axle housing on baseplate<br />
5x46 001 275.<br />
Install the pinion, helical and intermediate<br />
gear into the front axle housing<br />
in the correct positions.<br />
Place the gasket on the front axle<br />
housing.<br />
Important! (to avoid falsifying the<br />
measurement)<br />
The inscriptions on the gearwheels face<br />
down, into the front axle housing.<br />
Place measuring plate 5p01 002 704 on<br />
the front axle housing. Insert centring<br />
ring 5p01 070 357 into helical gear hole<br />
in measuring plate.<br />
Place the bearing shells on the pinion,<br />
helical and intermediate gears.<br />
Insert and tighten all screws through the<br />
front axle housing into the measuring<br />
plate. Place gearwheel holding plate 5x46<br />
002 173 on the measuring plate and<br />
secure it with 2 screws.<br />
Lift the front axle housing off the baseplate.<br />
Turn through 180° with handles on<br />
gearwheel retaining plate, and set the<br />
housing down on the handles.<br />
Next, tighten all screws.<br />
Place the front axle housing (turned<br />
through 180°) back in the baseplate and<br />
remove the gearwheel retaining plate.<br />
(Tightening torques: see Chapter 1.5)<br />
1.4/30<br />
CD<br />
5 HP 19 FL © ZF Getriebe GmbH Saarbrücken<br />
00009<br />
00010<br />
00012<br />
00/08/01