519FLA REPAIR MANUAL

1.4.4 Detent spring switch
Using a suitable tool or by hand, set the
detent disc to position N (Neutral).
Mount position gauge 5p01 002 609 on
the selector shaft and turn the gauge until
the locating pin in the transmission housing
engages in the gauge, then turn the
knurled screw to eliminate play.
Align the detent spring with centring
device 5x46 001 250 and in this position
screw the spring down.
Tighten the screw at the output end first.
(Tightening torques: see Chapter 1.5)
With auxiliary tool 5w04 000 583 turn
forward until distorsion angle is reached
Unscrew the position gauge, move the
selector shaft to all positions in turn and
then move it back to position “N”.
Note !
If assembly was correct, it should be easy
to push the position gauge on to the
selector shaft until it makes contact with
the transnission housing.
1.4/26
CD
5 HP 19 FL © ZF Getriebe GmbH Saarbrücken
00028
00029
00030
00/08/01