519FLA REPAIR MANUAL

Place the support plate on the intermediate
housing.
Attach the support plate to the measuring
plate with 6 screws 36.290 (M8 x 140)
and the intermediate housing to the
measuring plate with 6 screws 37.220
(M8 x 45).
Turn the intermediate housing through
180°, place it on the support plate and
remove the gear retaining plate.
Important:
Tightening procedure: see Chapter 4.3.1.
4.4.1 Front axle shaft bearing
projection
Place pressure bell 5p01 030 357 on the
measuring plate.
Place measuring bridge 5p01 010 357
over the pressure bell.
Place measuring bar 5p01 150 331 on the
measuring bridge and set the dial to “0”
at the pressure bell.
Place the pressure bell on the front axle
shaft outer bearing race.
Place the spring of fixture 5p01 000 357
over the pressure bell and fasten the
measuring bridge to the coreresponding
tapped holes in the measuring plate,
using 2 M8x80 screws with washers.
(Tightening torque 10 Nm)
4.4/2
CD
5 HP 19 FLA © ZF Getriebe GmbH Saarbrücken
00095
00096
00097
00/08/01