519FLA REPAIR MANUAL

Install two rectangular-section rings
73.140 on the carrier.
Insert disc set G, starting with spring disc
73.040 and continuing alternately with
steel discs 73.050 and lined discs 73.060.
Insert end disc 73.070 and secure it with
snap ring 73.080 .
Turn the complete unit round and remove
the counter-holding fixture.
Insert disc set D, starting with spring disc
73.010/160 and continuing alternately
with steel discs 73.010/170 and lined
discs 73.010/180.
Insert end disc 73.010/190 and secure
with snap ring 73.010/200.
Important:
If keys 73.012/210 were taken off when
dismantling, install them again.
Mount brake DG with first-gear flywheel
on clutch F and move in both directions
until the teeth and cutouts of the lined
plates engage fully with the inner disc
carrier.
Insert lifting fixture 5x46 000 545 into
the planet wheel carrier of the complete
planetary gear set (tower). Press down
the centre lever.
Note:
This is not possible if brake DG has been
mounted incorrectly on clutch F.
3.3/8
CD
5 HP 19 FL © ZF Getriebe GmbH Saarbrücken
99177
99178
99179
00/08/01