Igor Engraver Manual

APPENDIX A
294
cians included in the scores will not be affected, but you can change
whether individual scores are transposing or not using the Layout settings
dialog.
Score defaults, Fixed no. of bars per system:
When this box is checked, scores will always have a fixed number of bars
to each system. The fixed number is set in the box below.
Part defaults, Format:
This setting reflects the format that will be used for the piece’s part layouts.
The layout window reflects this setting: if you choose “B4 landscape”
instead of “B4 portrait”, the part layouts will be shown differently in the
layout windows. You can change the paper size for individual part layouts
using the Layout settings dialog after the parts have been created. We
strongly suggest that you change this setting to A4, Portrait or Letter, Portrait,
respectively if you are going to use a printer that cannot handle
larger sheets.
Part defaults, Music scaling:
In this textbox, you set the music scaling factor for parts. For example, a
scaling factor of 0.9 (90 percent) will display a layout with music that is
slightly smaller than a scaling factor of 1.0 would give.
Part defaults, Create titles:
When this box is checked, the title will automatically be included in the
header of the parts. (The title is input in the Piece information pane.)
Part defaults, Fixed no. of bars per system:
When this box is checked, parts will always have a fixed number of bars to
each system. The fixed number is set in the box below.