Igor Engraver Manual

39 CHAPTER 1
Installation and Setup
Click the upper here link to go register your first install of Igor Engraver. A new
window will open, as shown below.
Enter the challenge code where specified, make sure you have selected the right
operating system above that field, and click Submit to receive a response code.
Don’t do the following yet, but if you go back and update the previous page, you
will now see that one license has been used. You can also get a receipt from your
purchase from here, by clicking the lower here link.
Instead, copy the “response code” and paste the text into the Response: textbox of
Igor Engraver’s Challenge/Response window. Now the OK button will become
clickable. Press OK. Igor Engraver starts and the registration process is completed.
Return to your personal web page if you ever should need your second
install (e.g., your hard disk crashes), so REMEMBER TO KEEP YOUR URL
SECRET AND IN A SAFE PLACE. Note also that the licenses are cross-platform,
i.e., you can install your first license on a Macintosh and your second
license on a Windows computer if you want to (the Igor Engraver files are crossplatform
as well – see the next section in this chapter for more information).
1.12 Sharing Files Between Platforms
Igor Engraver files are completely cross-platform, e.g., you can save files on a
Macintosh and open them on a Windows computer, continue working on the file
on that machine and then do the final editing on another Macintosh. However,