Tender Documents - Oil India Limited

(v)
(vi)
(vii)
Approximate transportable dimension of one load should be confined
to 9 M (L) x 3.5 M (W) x 3 M (H).
Supply, storage, consumption / regulation of water & fuel at each
well site as well as at the camp site shall be the Contractor‟s
responsibility. Any shut down of operation due to non-availability of
water and fuel shall be on the Contractor‟s account.
Supply of LDO / LWC for mud preparation and for meeting other
downhole eventualities will be the Company‟s responsibility. The
Contractor shall also provide fuel for all of their vehicles and other
stationary engines.
(viii) All sorts of lubricants for day to day operation of various rig
equipments (for each rig) shall be supplied by the Contractor. Also,
various spares for rig components shall be stocked / arranged by the
Contractor.
(ix)
(x)
Well Logging Service: All logging requirements as depicted in the
Work over programme will be met by OIL through its in-house or
logging Contractors‟ service.
Well killing: During well killing, OIL will supervise the operation, the
necessary service shall be provided by the Contractor.
7.6 LIGHTING SYSTEM (for each rig): Explosion proof, suitable for hazardous
location with adequate lighting at all the important points. Mast lighting
system and area lighting system should be provided with proper fixing
arrangements, poles etc.
NOTE: STATUTORY REQUIREMENTS FOR ELECTRICAL ITEMS
All the equipment such as light fittings, plugs & sockets, junction boxes,
etc used in hazardous area must have CMRI (INDIA) certifications or
equivalent certification from competent authority from the country of origin
and the bidder has to forward the same along with the offer. Bidder shall
confirm categorically during the offer that approval of DGMS (INDIA) for
zone I, Gas group IIA & IIB for the same will be provided before
commencement of operation. The bidder should ensure that RED AVIATION
WARNING LIGHTS on the crown of the mast have been provided as per
Aviation Standards.
7.7 OTHER EQUIPMENTS: Contractor shall provide the following for each
rig:
a) Rig wise Equipments:
i) 3.1/2” OD Drill collars: 6 Nos.
ii)
Mud Motors for cement cleaning / milling of following
sizes:
1) 3.1/2” OD for 5.1/2” Casing (5/6 lobe configuration,
minimum flow rate 70 GPM, peak torque not less than