Tender Documents - Oil India Limited

7.11 BOP CONTROL UNIT: [As per API Spec. 16D with API monogram] for
each rig:
One 20 gallon capacity BOP control unit with remote panel and accessories.
Accumulator: 4 nos. of 5 gal capacity bladder type accumulators BOP
control unit shall be complete with electrical and air operated pressurizing
system, with auto pressure switch for both, capable of pressurizing up to
3000 psi. BOP remote control panel with visual display to be placed near to
the driller console. All electrical items should be suitable for hazardous
area, zone-1 gas group IIA & IIB.
NOTE: All wellhead equipment/ BOP/ BOP control unit should be pressure
tested and certified as per API recommended practice.
7.12 SAFETY DEVICES (for each rig):
(a) Fall Protection Device: An anti-fall coupled with safety harness/
belt shall be provided for personnel working on mast while exposed to
a fall of 3 meters or greater or climbing unprotected vertical ladder
with same exposure.
(b)
(c)
Top man’s Escape Line & Device: For evacuation of Top Man from
racking platform level in case of emergency. Escape device should
have a seat and a spring actuated cam brake.
Portable Gas Detectors: A portable DGMS approved gas detector
capable of determining/ monitoring level of combustible gases in air
should be made available at site. (Bidder should confirm to provide
DGMS approved Gas Detectors in their offer. However, DGMS
approval must be submitted before commencement of operation.)
NOTE: All safety equipments are to be in prime working condition.
7.13 General Statutory requirements for SAFETY NORMS:
a. All the moving / rotating parts like belts, couplings, drive lines etc.,
of the equipment should be well guarded and painted with red color.
b. SRV of the pumps and air reservoir tanks should be tested regularly
and records of such testing should be kept available all the times.
c. Proper color codes as per safety norms should be applied on the high
pressure lines, gas lines and water lines.
d. Anchoring and grouting of the delivery & bleed lines of the pumps
should be done before running the pump.
NOTE: Any other item/ assembly not incorporated above and needed
for meeting the scope of work in the tender should be provided by the
Contractor.