Tender Documents - Oil India Limited

5) Any additional requirement of crane(s) for any specific purpose
at site during well operation shall also be provided by the OIL
ii)
CONTRACTOR’S RESPONSIBILITY
1) Transportation of Contractor‟s personnel & their material from
camp site to drill site and between drilling sites shall be the
responsibility of the Contractor. All vehicles deployed for this
purpose should be in prime condition.
2) All requirements of crane(s), during rig up/rig down, interlocation
movements & any other job required for carrying out the
well operation are to be provided by the Contractor.
3) The Contractor must provide at their cost, equipment & services
of the following minimum number
Sufficient number of load carrying vehicles and cranes so
that the inter-location movement is completed without any
delay.
During Inter-location Movement, any left out consumables
including but not limited to, well head, casing, tubing or any
kind of tubulars, bits, chemicals, barytes, bentonite etc.
should be collected, loaded, unloaded, stored, handled,
transported between locations by the Contractor or as
directed by OIL.
Rig down / Rig up / transportation / maintenance of
Company‟s materials / items like Well killing pump,
Production installations (if any) attached to the rig shall be
done by the Contractor.
One truck with jugalis is to be provided for transportation of
Bits, Mills, light consumables, chemicals, etc. required for
preparation of mud and completion fluid, from Company‟s
yard/Godown. Loading/ Unloading is to be done by the
Contractor.
D. ELECTRICITY: Generation and supply of electrical power for running
the entire operation and for various uses in the camp and well site
shall be done by the Contractor.
i) RIG LIGHTING
1) All lighting fixtures, plug & sockets, junction boxes etc. used in
hazardous area shall be explosion proof or increased safety and
must have approval from DGMS (India) for use in Zone 1/ Zone
2, gas group IIA & IIB as statutory requirement.
2) Lighting cable should be multi core flexible copper cables, 1000
volts grade (armored or screened), electrometric rubber
insulated, CSP/NBR sheathed.