VL2000 ug finalcomp.book - Kodak

Job Setup
Setting Up a Print Job
17. Select Print to view the transport work area.
18. Select Verify to compare the printing system to the job requirements.
a. Correct any warnings or errors as needed.
b. Select Yes to continue.
19. Select each Printhead.
a. If necessary, modify the Cue sensor, Mount, Color, and Page
correlation information.
b. Select Apply to save the changes.
20. Select each Cue sensor.
a. If necessary, change the cue definition to match the Job Setup
Sheet.
b. Select Apply to save the changes.
Note: Perform these steps if the printing system setup is changed from
the original configuration. If it is the original configuration, go to
“Printing Test Pages” on page 174 or “Printing a Print Job” on page
174.
21. Select Unwind.
a. Enable the module and set the unwind tension.
b. Select Apply to save the changes.
22. Select each Print tower.
a. Enable the module.
b. Select Apply to save the changes.
136 KODAK VERSAMARK VL2000 Printing System