VL2000 ug finalcomp.book - Kodak

Using an MPC Manual Setup
Overriding the Default Settings for a Single MPC Job
Messages
1. Select the message.
The message appears in an edit box in the tab. All characters on the
keyboard can be used, including punctuation marks and symbols.
2. Make necessary changes.
3. Select the Apply button when you are done.
Adding a Message Use the steps that follow to create a new
message.
1. Select under the Fixed Messages heading.
2. Select the message number (such as Message 1) to be added.
3. Select the Apply button.
4. Enter the message.
5. Select the Apply button.
Deleting a Message Use the steps that follow to delete a message.
1. Select the message (such as Message 1).
2. Select the Remove Message button at the right edge of the tab.
Operator’s Guide 249