VL2000 ug finalcomp.book - Kodak

Positioning the Page Correlation Sensors
Positioning the Page Correlation Sensors
Four page correlation sensors are on a double rail in the outfeed module
(Figure 80). Use the following steps to adjust the sensor positions across
the web.
Figure 80
Page correlation sensors, outfeed module
Page correlation sensors
for front
Knob
1. Perform the steps in “Setting Up Page Correlation” on page 150.
2. At the outfeed module, rotate knob to move a sensor to its correlation
mark.
• Turn the knob CCW to move the sensor to GS.
• Turn CW to move it OS.
3. Repeat step 2 for each used sensor.
4. If necessary, go to “Adjusting the Cue Sensor” to continue cue sensor
setup.
5. Print the job at a slow speed, and check each sensor for detecting the
page correlation marks.
6. If necessary, repeat step 2 to fine-tune the sensor position.
7. Perform “Saving the Job Settings” on page 157.
8. At the system controller, enter a starting document number where you
want to start printing with page correlation.
9. Resume printing the job.
156 KODAK VERSAMARK VL2000 Printing System