VL2000 ug finalcomp.book - Kodak

Table 3
Controller Set or adjust dryer temperature As needed 1 min
Controller Set or adjust web speed As needed 1 min
Controller Setup and adjust page correlation system As needed 15 min
Controller Assign logical printers Job
2 min
dependent
Controller Clean cabinet Weekly 5 min
per
Controlle
r cabinet
Dryer Clean (vacuum out paper dust, wipe ink Monthly 10 min
off of dryer drum, etc.)
Folder “Clean the Cue Sensor Lenses” on page Monthly
297
Print
stations
Acknowledge status and error messages As needed 5 min
Print
stations
Print
stations
Print
stations
Print
Stations
Print Tower
Remove waste container and dispose of
waste
Replenish fluids
As needed
As needed.
(Check at
beginning
and end of
each shift
15 min
10 min
Clean print station exterior Weekly 30 min
“Perform Print Station Maintenance” on
page 299
“Replace the Web Cleaner Pre-Filters” on
page 299
Print Tower Setup and adjust line hole cueing system As needed 15 min
Print Tower “Clean the Cue Sensor Lenses” on page Monthly
297
Print Tower “Clean the Web Cleaner Internal Monthly
Components” on page 297
Print Tower “Clean and Check the Indicator Lamps” Quarterly
on page 299
Printheads Recognize and correct print quality As needed 15 min
problems
Printheads Adjust printhead position As needed, at
printhead
replacement
10 min
Printheads Verify print quality Continuously
while printing
throughout
the shift
Rewind
Rewind
Rewind
Unit
System
Sample operator responsibilities, VL2000 (Continued)
Module Task Frequency
“Clean and Check the Air Shafts” on
page 299
“Clean and Check the Indicator Lamps”
on page 299
“Perform Rewind Unit Maintenance” on
page 299
“Check the Operation and Safety” on
page 299
Quarterly
Quarterly
Time
required
N/A
294 KODAK VERSAMARK VL2000 Printing System