Precipitator Optimization System User Manual - Neundorfer, Inc.

More documents

Recommendations

Info

Precipitator Optimization System 7 User Manual The Start button begins the data capture and transfer from the voltage control to the POS computer. After pressing the Start the user can change the scope setup and begin another trace by pressing the start button again. This action aborts the running data capture and begins a new one. The line of text at the bottom of the trace contains a status message and the setup information for the displayed scope trace. The Select MVC dropdown list contains a list of all the voltage controls on the precipitator. The control selected on this list is the control that will generate the oscilloscope traces. The Trace Type drop down list lets the user select what type of data the user wants to display. High Speed Data displays traces like those captured with a traditional oscilloscope. The signals that can be graphed include Primary Current, Primary Voltage, Secondary Current, Secondary KVa, Secondary KVb, and Conduction Angle. The Primary Averages trace type is similar to a trend graph or a graph of face panel data except at a much higher data capture speed. The signals that can be graphed include Primary Current, Primary Voltage, Secondary Current, and Conduction Angle. The KvMin/Max plots a graph of the secondary voltage minimum and maximum values of each half cycle of the line. The signals that can be graphed include Secondary Current, Secondary Kva min, Secondary KVb max, and Conduction Angle. The Trigger dropdown list is where the user selects which event the control will begin its data capture. The list includes Primary Current Limit, Primary Over Voltage Limit, Secondary Current Limit, KV Limit, Conduction Angle Limit and Spark. The trace generation is event driven and the user must select a trigger event that actually occurs in the MVC for the data capture to begin and be transferred to POS. The Sweep Speed drop down list is where the user selects the rate at which the data will be gathered. This list will vary depending on the Trace Type selected. Pressing the Store button saves the scope data to the CSV directory as a CSV file. The Retrieve button brings that data back into POS for display. You can load the raw scope CSV data into a spreadsheet application, the file is typically stored in the c:\vts\pos7\csv directory. The Print button is used to send the graph image to any configured printer in the operating system. Copyright © 2007 Neundorfer, Incorporated Specifications and Features subject to change without notice 08/01/07 16
Precipitator Optimization System 7 User Manual 11. Remote View Pressing the Remote View button opens a window showing an MVC display panel with current operating values. This window operates identically to the actual voltage control display panel. Buttons that change operating set points are password protected. For MVC operation please refer to the user manual that shipped with the control. MVC Remote View Copyright © 2007 Neundorfer, Incorporated Specifications and Features subject to change without notice 08/01/07 17
Page 1 and 2: Precipitator Optimization System 7
Page 15: Precipitator Optimization System 7
Page 67 and 68:
Precipitator Optimization System 7
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105:
show all

Precipitator Optimization System User Manual - Neundorfer, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?