Precipitator Optimization System User Manual - Neundorfer, Inc.

Precipitator Optimization System 7
User Manual
System Parameter Transfer
System Transfer Tab
System Parameters are for the configuration of the rapper control setup information and is
independent of rapper programs. System parameters include rapper type, the number of retries
for failed rappers and line frequency. The system parameters can be edited by right clicking the
rapper control icon and selecting properties from the menu or in the POS Points.MDB file.
When editing the system configuration it is always best to insure that the rapper types
are still set correctly in the MicroRap. This can be done with the hand held terminal. If
the rapper types are not correct, you run the risk of burning up rapper coils of impact
type rappers.
Send to Control - Transfers system parameters from the POS computer to the rapper controller.
Get from Control - Transfers system parameters from the MicroRap to the POS computer.
If you would like to compare the POS and MicroRap system parameters before uploading or
downloading them, we recommend that you print the system parameters out using the printing
function. The Rapper Controller Parameter Print allows you to print rapper programs from three
different sources. These sources are a specific Controller Parameters number, a Disk
Parameters or the Last Parameters Transferred to or from the rapper control. Select the
appropriate source and press the Print button.
Copyright © 2007 Neundorfer, Incorporated
Specifications and Features subject to change without notice
08/01/07
37