Precipitator Optimization System User Manual - Neundorfer, Inc.

Precipitator Optimization System 7
User Manual
This section of the screen lists
the number of steps (in order of
execution), the step back
percentage, and the number of
voltage controls in the step.
The Insert Step button will
insert a step at the selected
location.
The Add button will insert a
new step at the end of the
program.
The Delete Step will delete the
selected step.
The step back percentage can
be adjusted by selecting a step
and then adjusting the Percent
bar. The percent bar can be
adjusted by clicking and
dragging the bar, pressing the
up and down arrows or typing a
number in the numerical
readout below the graph. The
Percentage Bar represents a
percentage of full secondary
current for the TR Set.
This is where T/R sets can be added or
removed from the step currently
highlighted in the Step Selection box.
The Available list shows all TR sets for
this precipitator that can be included on
this step of the program. The Included
box displays the unit names for the
selected T/R sets in this particular
optimization step.
In the T/R Set Selection box you can
add or delete voltage controls used in
this optimization step. There are two
methods of adding controls. The first
method is visually from the Plan View
window. The other is by selecting T/R
sets from the Available box.
T/R Set Selection Box
Copyright © 2007 Neundorfer, Incorporated
Specifications and Features subject to change without notice
08/01/07
68