Precipitator Optimization System User Manual - Neundorfer, Inc.

Precipitator Optimization System 7
User Manual
Power optimization is not permitted to run while SO3 optimization is tuning the feed rate. If power
optimization is running, it will abort back to the first step and remain there until the SO3
optimization module concludes the tuning process. When power optimization is re-enabled, it will
start the program at the first step and proceed through the program at its normal rate. The
controls selected in the SO3 optimization module for power monitoring will not have their power
levels adjusted by power optimization while the S03 optimization module is running.
SO3 optimization actions will be logged to disk anytime SO3 optimization is turned on in POS.
The log will be the traditional file per day per point format. Each log entry contains the time and
date stamp, SO3 enable input, PPM input, opacity (rolling avg.), load (rolling avg.) and power
reading (rolling avg.). Each log entry will also contain text describing the action it has performed.
The log interval will be the same as the “Wait Time” setting.
When a user turns off SO3 optimization, POS will restore the SO3 PPM to the default feedrate.
The PPM Graph displays a trend graph of the PPM of Sulfur fed into the system over time.
The Opacity Graph displays a trend of Opacity over time.
The Power Graph displays a trend of the Power Parameter selected in the System Settings
Window.
Set Axis
The Set Axis button opens the Set Axis window. To change the X-Axis Scaling,
click on the corresponding radio button to display 1 Day, 3 Days, 1 Week, or 3
Weeks of data at a time.
Print Charts
The Print Charts button will open up a Print Preview window that will allow you to
print the PPM, Opacity, and Power graphs displayed on the screen.
Set X-Axis Window
When SO3 Optimization is enabled, the Start button can be used to begin the optimization process.
The window displays whether SO3 Optimization is enabled, the Default PPM, and the Optimized
PPM. Pressing the Configure button opens the Configuration Window.
Copyright © 2007 Neundorfer, Incorporated
Specifications and Features subject to change without notice
08/01/07
97