Precipitator Optimization System User Manual - Neundorfer, Inc.

Precipitator Optimization System 7
User Manual
The following data can be displayed on the 3D Graphs:
Live Data:
Primary Current - T/R sets Primary Current
Primary Volts - T/R sets Primary Volts
Secondary Current - T/R sets Secondary
Secondary KVa - T/R sets Secondary Kilovolt A bushing
Secondary KVb - T/R sets Secondary Kilovolt B bushing
Primary KW - T/R sets Primary Kilowatt
Secondary KW - T/R sets Secondary Kilowatt
SCR Angle - SCR Conduction Angle
Actual Sparks /Min - Sparks per minute
Set points and limits:
Sparks Sensitivity – How the control responds to sparks
Optimization Percent - Optimization Percent
Secondary Current Limit - Voltage Control Secondary Current Limit
IE Ratio - Number of On and Off Half Cycles
Primary Current Limit - Voltage Control Primary Current Limit
Primary Over Volts Limit - Voltage Control Primary Over Voltage Limit
Primary Under Volts Limit - Voltage Control Primary Under Voltage Limit
Secondary Current Limit StPt - Secondary Current Limit Set by POS
Rap Limit - Secondary Current Limit Set for Power Off or Reduced Rapping
Secondary KV Limit - Voltage Control Secondary Kilovolt Limit
Spark Baseline Rate - Voltage Control Sparks per minute Set Point
Spark Response Mode - Voltage Control Spark Mode
SCR Cond Angle Limit - Voltage Control SCR Conduction Angle Limit
MVC Device Number - Voltage Control Address
Back Corona Setup Code - Voltage Control Back Corona Detection Setup Code
IE Ratio POS Set Point Code - IE Ratio POS Set Point Code Set by POS
Full Scale Secondary Current – Voltage Control Full Scale Secondary Current in Milliamps
Secondary Current Density – Ratio of Secondary Current over collecting plate size
Copyright © 2007 Neundorfer, Incorporated
Specifications and Features subject to change without notice
08/01/07
60