PDF：7.7MB

TAC Mills
TGP4100RBAE
Standard cutting conditions
Work materials
Cast irons
Ductile cast irons
Mild steels
Unhardened steels
(< 180 HB)
Carbon steels
Alloy steels
(< 300 HB)
Carbon steels
Alloy steels
(> 300 HB)
Die steels
(< 30 HRC)
Stainless steels
(< 250 HB)
Grades
T1115
TH10 • UX30
FX105
NS740 • N308
AH120 • GH330
T3130
UX30
T3130
NS740 • N308
AH330 • AH120
UX30
T3130 • GH330
NS740 • N308
UX30
T3130
UX30
AH120 • AH140
UX30
Roughing (Depth of cut: ap 1.5 ~ 4 mm)
Finishing (Depth of cut: ap 0.3 ~ 0.7 mm)
Cutting speed v c (m/min) Feed per tooth fz (mm/t) Cutting speed v c (m/min) Feed per tooth fz (mm/t)
100 ~ 200
100 ~ 200
80 ~ 130 0.1 ~ 0.2
80 ~ 130
0.1 ~ 0.23
200 ~ 500 200 ~ 600 0.1 ~ 0.3
150 ~ 250
0.1 ~ 0.18
0.1 ~ 0.23
150 ~ 250
0.1 ~ 0.23 0.1 ~ 0.25
150 ~ 300
180 ~ 300
0.1 ~ 0.25
100 ~ 180 130 ~ 200
0.1 ~ 0.28
150 ~ 280 0.1 ~ 0.23 180 ~ 280 0.1 ~ 0.25
100 ~ 180 0.1 ~ 0.18
100 ~ 200 0.1 ~ 0.2
150 ~ 200 0.1 ~ 0.23
80 ~ 130 0.1 ~ 0.23 100 ~ 150 0.1 ~ 0.25
150 ~ 230 0.1 ~ 0.23 180 ~ 280 0.1 ~ 0.25
100 ~ 180 0.1 ~ 0.18 150 ~ 200 0.1 ~ 0.23
80 ~ 130 0.1 ~ 0.23 100 ~ 150 0.1 ~ 0.25
100 ~ 150
100 ~ 150
0.1 ~ 0.15
80 ~ 130 80 ~ 130
0.1 ~ 0.2
150 ~ 230 0.15 ~ 0.2 200 ~ 250
150 ~ 180 0.15 ~ 0.2 180 ~ 200
0.15 ~ 0.23
Notes: • Dry cutting is recommended for above materials.
• When wet machining mild steels, carbon steels and alloy steels, use T3130 at lower cutting conditions.
9
TAC Mills
• No. of revolutions (min -1 ) = Cutting speed 1000 ÷ 3.14 ÷ Cutter diameter
• Table feed (mm/min) = No. of revolutions Feed per tooth No. of inserts
9–52
Technical Reference
(15-1)