AutoCAD® 2002 - Autodesk

ting used in this table, see “Formatting Conventions in This Reference” on
page 6.
Radial and diameter dimension group codes
Group codes
Description
100 Subclass marker (AcDbRadialDimension or AcDbDiametricDimension)
15 Definition point for diameter, radius, and angular dimensions (in WCS)
DXF: X value; APP: 3D point
25, 35 DXF: Y and Z values of definition point for diameter, radius, and
angular dimensions (in WCS)
40 Leader length for radius and diameter dimensions
The point (15,25,35) specifies the first point of the dimension line on the circle/arc
and the point (10,20,30) specifies the point opposite the first point.
The point (11,21,31) specifies the midpoint of the dimension text.
The point (15,25,35) specifies the first point of the dimension line on the circle/arc
and the point (10,20,30) specifies the center of the circle/arc. The
point (11,21,31) specifies the midpoint of the dimension text.
Angular Dimension Group Codes
The following group codes apply to angular dimensions. In addition to the
group codes described here, those listed in “Common Group Codes for Entities”
on page 60 and “Common Dimension Group Codes” on page 69 can
also be present. For information about abbreviations and formatting used in
this table, see “Formatting Conventions in This Reference” on page 6.
Angular dimension group codes
Group codes
Description
100 Subclass marker (AcDb3PointAngularDimension)
13 Definition point for linear and angular dimensions (in WCS)
DXF: X value; APP: 3D point
23, 33 DXF: Y and Z values of definition point for linear and angular
dimensions (in WCS)
14 Definition point for linear and angular dimensions (in WCS)
DXF: X value; APP: 3D point
74 | Chapter 6 ENTITIES Section