Download - Wolfram Research

3.10 Interfaces 373
ReadNetlist["netfile", "outfile", Simulator −> "PSpice"] additionally scans the operating-point
information section in the output file outfile. Afterwards the circuit is flattened via an internal call
to ExpandSubcircuits and the small-signal parameters are appended to the corresponding model
instance. The parameter names are postfixed with "$ac" to avoid ambiguities.
Eldo
ReadNetlist["netfile", Simulator −> "Eldo"] supports the following devices:
Eldo reference designator
C
D
E
F
G
H
I
J
L
M
Q
R
V
X
Y
Analog Insydes type
Capacitor or model call
model call
VCVSource or model template
CCCSource or model template
VCCSource
CCVSource
CurrentSource
model call
Inductor or model call
model call
model call
Resistor or model call
VoltageSource
subcircuit call
model call
Eldo reference designators supported by ReadNetlist.
All model calls have functions as references for Model, Selector, and Parameters were applicable:
{rd, {n 1 −> p 1 , },
Model −> Model[type, model, rd],
Selector −> Selector[type, model, rd],
Parameters −> Parameters[type, model, rd], }
where type is one of "BJT", "CAP", "Diode", "IND", "JFET", "MOSFET", or "RES". The value model
is the model name, rd the reference designator of the device.